![]() In above code,i used i2c for eeprom interfacing and mcp23017 io expander.Essentially, you have a set of ‘row enable’ DO pins, and only one is ![]() The operation is ended with a Stop (P) or Restart (SR) condition being generated by the master. Once configured, you can use any of the 16 pins as pins for your projects. Both “byte writes” and “sequential writes” are As I’m using I2C I only need four connections: VCC, GND, SCL and SDA (I could have left off the other You have to add this declaration in your device configuration file if you like to use also BeforeWriteOutputs method: I haven't deep dived in the MCP23017 device datasheet yet. This development board communicate to the microcontroller using I2C interface and increases the number of input-output pins of microcontroller. MCP23017 uses high speed I 2 C interface while MCP23S17 used high speed SPI interface. For the LED bar circuit, we will blink the LEDs with blink without delay, using the millis() function. The 16-bit I/O port functionally consists of two 8-bit ports (PORTA and PORTB).
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |